Menu

Features of HPG3 High Efficiency Gear Pumps

Features of HPG3 High Efficiency Gear Pumps

Hover to magnify, click for full size

The HPG3 series hydraulic gear pump is an external gear pump researched, developed and produced by HAIGTS with advanced technology, featuring automatic axial clearance compensation and radial hydraulic balance. It adopts a three-piece structure located by a figure 8 spigot, with bushings fitted inside the cast aluminum alloy front and rear covers and a special cast iron middle body. It is therefore impact resistant and covers a wide range of oil temperatures and rotating speeds, even

The HPG3 series hydraulic gear pump is an external gear pump researched, developed and manufactured by HAIGTS using advanced technology with automatic axial clearance compensation and radial hydraulic balance. It adopts a three-piece structure located by an 8-shaped spigot; bushings are fitted inside the cast aluminum alloy front and rear covers, and the intermediate body is a special cast iron component. It is therefore impact resistant, suits a wide range of oil temperatures and rotational speeds, and keeps a high volumetric efficiency and mechanical efficiency even at high temperature and low speed.

The maximum pressure can reach 25Mpa; the continuous operating pressure is above 20Mpa.

Suction pressure: -0.02 ~0. 2 MPa;

Fluid: hydraulic oil (engine oil is not suitable), viscosity: 9~430mm²/s

Oil temperature: normal use: 50℃-80℃ (80℃, 100℃: short term, -20℃~5℃: short term without load)